:oops:

I had the DirectX Debug Service Running.

All Working


Like the subject says :cry: ...

XP SP2 RC1 buggered up my driver install, and I've just done a clean driver install, but no picture.

When I connect to the graph, the SpectrumTV Filters show up Orange just in case anyone knows what that means. The graph looks complete otherwise.

When I hit F in DW to cycle through the filter property pages, DW hangs (reboot required) when it gets to the tuner filter.

After I reboot, I'll have a bit more of a play.

...OK, only thing that I can see is the Network Provider loaded by DW has no properties page when I display the graph in GraphEdit. If I add the Microsoft DVBT Network Provider filter to a new graph manually, I can see the properties page, set the frequency etc and submit a tune request. If I add the spectrum DTV filters, I can render the antenna pin and get a fully built graph - which doesn't play.

Ahh Well, back to TH for me :roll:

BJ

Is the SP2 RC1 build number 2096?

Yup

I can confirm that it does work

Well, thats both helpful and not all that helpful at the same time :?

I thought I'd check on my PC now, rather than when SP2 is released, so I would know how to proceed with the HTPC.

Any special hints?

Did yours work after applying SP2 right away?

ta

BJ

Everything worked fined. i think i installed 1.4.4.0 first. then upgraded to 1.4.5.0 when it was released. some people have had problems installing 1.4.5.0 due to a dodgy inf file.

make sure you've got the longhorn mpg2splt.ax posted by spectrum.

All channels work exect for SBS and gthe datacasting channels. i have had some audio probs and a channel change fixes this.

I have a similar thing but with a fresh install of WindowsXP Pro SP1.

The drivers install OK and when I connect up the graph in GraphEdit the video plays fine, all the connections are there but I hear no audio.

Now just try and change channels either in GraphEdit or DW and instantly BSOD with message "This error seems to have been caused by thbdacap.sys......"

Went to all the trouble of uninstalling the filters etc and following Spectrum's instructions implicitly, reinstalling. When that didn't work I reinstalled Windows just to eliminate a bad install possibility.

Now I have to admit I also have a Twinhan Sat-CI card indepentently running on TH drivers but previous Spectrum drivers ran OK concurrently with this, although a little buggy, without the BSOD. I'll wait for the next Spectrum driver I think.

cheers

Doh :oops: My Bad.

DirectX Debug Service was running.

Yeah, I had to hack the inf for the capture driver. Haven't yet got the mpg2splt.ax but all working OK.

Thanks for the suggestions.